Introduction; Fast Valve Set-Up; Configuration; Power Supply - Bernard Integral+ Commissioning Instructions

1 INTRODUCTION

The configuration panel of the INTEGRAL+ board allows to adapt the actuator at each particular
application. Information to be transmitted and actuator behaviour configuration are set with swit-
ches and jumpers. The actuator is deliverable with standard configuration, or optional configuration
if requested at order. The configuration can be easily changed on site.
The jumper and switches settings can be reported in a table on page 39.

2 FAST VALVE SET-UP

If the INTEGRAL+/POSIGAM+ control doesn't need specific configuration, you can refer directly to
the detachable document located in the center of this document for a fast and easy setting of
the valve position. This description considers valve closing on position. For POSIGAM+, description
considers input/output signals are 4/20mA.
For specific parameters, please follow the descriptions in the following chapters.

3 CONFIGURATION

Configuration is easily done by changing switches and jumpers position.
Figure 2
Switches configuration
Basic/standard" configuration (default setting): all switches and jumpers are in position A.

4 POWER SUPPLY

4.1 ACTUATOR POWER SUPPLY

Actuator power supply can be 3 phase, single phase or DC.
Jumper 100 (located at the bottom of the board)
The electronic board includes an automatic phase correction device and a detection of missing
phase device. In 3 phase supply, whatever the power connection, the actuator always rotates
in the right direction. If, in 3 phase supply, one phase is lost, the actuator stops automatically
and the monitoring relay drops.
4
Figure 3
Jumpers configuration