Mode Button; Setting The Dmx Address; Setting Presets And Sequences - ETC ColorSource Linear Installation Manual

ETC Installation Guide
ColorSource Linear v1.5

Mode button

Pressing the Mode button activates the Preset/Sequence menu; the last active
preset or sequence plays automatically. Pressing the Mode button a second
time deactivates the selected preset or sequence. The display will revert to
show the DMX start address.
• If DMX data is present, the current preset or sequence plays in the
background and DMX data continues to take priority.
• If DMX data is lost and a preset is active in the background, the last
selected preset or sequence automatically plays.

Setting the DMX address

1: Press the Mode button until the DMX address is displayed.
2: Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See

Setting presets and sequences

There are twelve factory-configured presets followed by five factory-
configured sequences built into the fixture. From the Preset/Sequence menu,
press the Up and Down buttons to scroll through the list. The sequence or
preset plays immediately upon selection. All presets and sequences can be re-
recorded through an RDM device.
When a Linear 2 or Linear 4 fixture is in Cell mode, you can re-record a preset
with each cell having a distinct set of values. See
page 9
on
Re-recording a preset
1: Using DMX or RDM, set the desired levels.
2: Press the Mode button to access the Preset/Sequence menu.
3: Using the Up and Down buttons, navigate to the preset number that
you want to re-record.
4: Hold the Mode button for 3 seconds to confirm the preset selection.
The user interface will show a 3-second countdown. The preset
number blinks once to confirm that the preset has been recorded.
Note: When the fixture is in Direct mode (
ColorSource Linear v1.5
.

mode ( ), you cannot re-record presets.
When you re-record presets with the fixture in RGB

mode ( ), the intensity is set to full and the strobe is
turned off.
See
Changing the DMX control mode
Page 7 of 16
Using RDM page 16
on
Setting the Grouping mode

) or 1-channel
on
page 9.
.
ETC