Port Led On The Interface Card - HP A5500 HI Series Installation Manual

Table 21 Interface card status LED description
LED mark
SLOT1/SLOT2

Port LED on the interface card

The interface cards available for the A5500 HI switches provide one port LED for each port. Except for
the LSPM2SP2P card, see their user guides for port LED description.
The LSPM2SP2P interface card, when used on an A5500 HI switch, supports not only 10 Gbps SFP+
transceiver modules and cables, but also 1000 Mbps SFP transceiver modules.
LED behaviors.
Table 22 Port LED description for the LSPM2SP2P interface card
Port mode
(Mode)
Steady green (rate
mode)
Steady
(duplex mode)
Status
Steady green
Flashing yellow
Off
LED Port LEDs
LSPM2SP2P card
Steady green
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
yellow
Flashing yellow (3 Hz)
Off
Description
The interface card is in position and operating properly.
The slot does not support the card model, or the card has
failed.
The expansion interface card slot is empty.
on the
Description
The port is operating at 10 Gbps. The port LED fast
flashes when the port is sending or receiving data.
The port is operating at 1 Gbps. The port LED fast
flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
The port is operating in full duplex mode. The port LED
fast flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
56
Table 22 describes its