Table 12 10/100/1000Base-T Ethernet port specifications
Item
Connector type
Interface attributes
Max
distance
Transmission medium
Standards
100/1000Base-X SFP port
Every A5500 HI switch has four fixed 100/1000Base-X SFP ports. You can install the modules listed in
"100 Mbps SFP transceiver
SFP+ port
Every A5500 HI switch has two fixed 1-/10-Gbps SFP+ ports. You can plug the transceiver modules and
cables in
"1000 Mbps SFP transceiver
into the SFP+ ports as needed. You can use the SFP+ ports as IRF physical ports to connect A5500 HI
switches in an IRF deployment.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table 13 System status LED description
LED mark
SYS
Specification
RJ-45
•
10/100 Mbps, half/full duplex, auto MDI/MDI-X
•
1000 Mbps, full duplex, auto MDI/MDI-X
transmission
100 m (328.08 ft)
Category-5 (or above) twisted pair cable
IEEE 802.3i, 802.3u, 802.3ab
modules" and
Status
Steady green
Flashing green (1 Hz)
Steady red
Flashing yellow (1 Hz)
Off
"1000 Mbps SFP transceiver
modules" and
"10 Gbps SFP+ transceiver modules/SFP+
Description
The switch is operating properly.
The switch is performing power-on self test
(POST).
POST has failed.
Some ports have failed to pass POST.
The switch is powered off.
51
modules" in the ports.
cables"
Need help?
Do you have a question about the A5500 HI Series and is the answer not in the manual?