Table of Contents
Advertisement
1.2
Inspection Checkpoints
Receiving Checkpoints
Checkpoints
Does the power regenerative unit model number correspond with the
purchase order?
Are any parts damaged?
Is hardware properly seated and securely tightened?
If any of the above checkpoints are not satisfactory, contact your YASKAWA representative.
Checking the Nameplate Data
Nameplate Data
Example of standard domestic model CIMR-R5U2011.
Figure 1.1
Model Designation
Figure 1.2
Power Regenerative
Unit
Symbol
U
A
Symbol
2
4
Protective Structure
• Open Chassis Type (IEC IP00)
Protected so that parts of the human body cannot reach electrically charged parts from the front when the Power regenerative unit is mounted in a
control panel.
• Enclosed Wall-mounted Type (IEC IP20, NEMA 1)
The power regenerative unit is structured so that the power regenerative unit is shielded from the exterior, and can thus be mounted to the interior
wall of a standard building (not necessarily enclosed in a control panel). The protective structure conforms to the standards of NEMA 1 in the
USA.
YASKAWA ELECTRIC TOEP C710656 01C YASKAWA - RC5 Instruction Manual
CIMR - R5 U 2 011 1 A
VS - 656RC5 Series
Specifications
Standard domestic model
Japan standard model
Voltage
3-phase 200 V class
3-phase 400 V class
Figure 1.2 Model Designation
Table 1.1 Checkpoints
Check the model number on the nameplate on the side of the RC5. (Refer to
Visually check the exterior and verify that there was no damage during transport.
Remove the front cover of the power regenerative unit.
Check all visible hardware with appropriate tools.
Figure 1.1 Nameplate Data
Version (Enter the specifications
form number when special speci-
fications are required.)
No.
0
1
Symbol
Max. applicable motor output
3P7
3.7kW
5P5
5.5kW
to
37
37kW
"P" indicates the decimal point.
1.2 Inspection Checkpoints
Description
Protective Structure
Open chassis (IEC IP00)
Enclosed wall-mounted
(IEC IP20, NEMA1)
to
Figure
1.2.)
13
Advertisement
Table of Contents
