Table of Contents
Advertisement
4.5 Digital Operator Modes
Operation Mode
Operation mode is the mode in which the power regenerative unit can be operated.
Many user parameters can't be changed when the power regenerative unit is operating.
Viewing monitor displays, fault information and fault history are possible in operation mode.
Note: When running the power regenerative unit after using digital operator, press the MENU Key to enter the operation mode and then press the DATA/ENTER Key from the
operation mode display to bring up the monitor display. Run commands can't be received from any other display. (Monitor display in the operation mode appears when
the power is turned ON.)
Operations in Operation Mode
Key operations in operation mode are shown in
Figure 4.4
All modes /parameters
status
Operation Mode
** Main Menu **
Operation
42
Figure
4.4.
MENU
DATA
DC Bus Voltage display
ENTER
ESC
Output current on power side
Power supply frequency
(can be changed at parameter o1-01)
Function selection U2 (fault trace)
Function selection U3 (fault history)
Function selection U1 (Monitor)
Figure 4.4 Operations in Operation Mode
Power ON
(When o1-02=2 )
DC Bus Voltage
U1-02 = 300 VDC
Output Current
U1-05 = 0.0 A
Ac Frequency
U1-08 = 60.00 Hz
Function U2
Fault Trace
Function U3
Fault History
Function U1
Monitor
YASKAWA ELECTRIC TOEP C710656 01C YASKAWA - RC5 Instruction Manual
Power ON
(When o1-02=3)
Power ON
(When o1-02=4)
Contents of fault trace
DATA
ENTER
Current Fault
None
ESC
DATA
Contents of fault history
ENTER
Last Fault
None
ESC
Various monitors
DATA
ENTER
DC Bus Voltage
U1-02 = 300 VDC
ESC
Advertisement
Table of Contents
