Table of Contents
Advertisement
To help ensure safe operation, please take a moment to learn the machine's applications and limitations,
as well as potential hazards. General
harmless for any injury that may result from the improper use of it's equipment.
1.
Do not operate the drill press when tired, distract-
ed, or under the effects of drugs, alcohol or any
medication that impairs reflexes or alertness.
2.
The work area should be well lit, clean and free of
debris.
3.
Keep children and visitors at a safe distance when
the drill press is in operation; do not permit them
to operate the drill press.
4.
Childproof and tamper proof your shop and all-
machinery with locks, master electrical switches
and switch keys, to prevent unauthorized or unsu-
pervised use.
5.
Stay alert! Give your work your undivided atten-
tion. Even a momentary distraction can lead to
serious injury.
6.
Fine particulate dust is a carcinogen that can
be hazardous to health. Work in a well-ventilated
area and whenever possible use a dust collector
and wear eye, ear and respiratory protection de-
vices.
7.
Do not wear loose clothing, gloves, bracelets,
necklaces or other jewelry while the drill press is in
operation.
8.
Be sure that adjusting wrenches, tools, drinks and
other clutter are removed from the machine and/
or the table surface before operating.
9.
Keep hands well away from the drill bit and all
moving parts. Use a hold-down or clamp to se-
cure the stock, and use a brush, not hands, to
clear away chips and dust.
10.
Be sure that the drill bit is securely installed in
the chuck before operation.
11.
Be sure the drill bit has gained full operating
speed before beginning to drill. Always use a
clean, properly sharpened bit. Dirty or dull bits
are unsafe and can lead to accidents. Use suit-
RULES FOR SAFE OPERATION
International disclaims any real or implied warranty and hold itself
®
able work piece support if the work piece does
not have a flat surface.
12.
Do not push or force the bit into the stock. The drill
will perform better and more safely when working
at the rate feed for which it was designed.
13.
Avoid working from awkward or off balance po-
sitions. Do not overreach and keep both feet on
floor.
14.
Keep guards in place and in working order. If
a guard must be removed for maintenance or
cleaning be sure it is properly re-attached before
using the tool again.
15.
Never leave the machine unattended while it is
running or with the power on.
16.
Use of parts and accessories NOT recommended
by GENERAL® INTERNATIONAL may result in equip-
ment malfunction or risk of injury.
17.
Never stand on machinery. Serious injury could
result if the tool is tipped over or if the drill bit is
unintentionally contacted.
18.
Always disconnect the tool from the power
source before servicing or changing accesso-
ries such as bits, or before performing any main-
tenance, cleaning, or if the machine will be left
unattended.
19.
Make sure that the switch is in the "OFF" posi-
tion before plugging in the power cord.
20.
Make sure the tool is properly grounded. If
equipped with a 3-prong plug, it should be used
with a three-pole receptacle. Never remove the
third prong.
21.
Do not use this drill press for other than its
intended
use. If
GENERAL® INTERNATIONAL disclaims any real im-
plied warranty and holds itvself harmless for any
injury, which may result from that use.
used
for
other
purposes,
5
Hide quick links:
Advertisement
Table of Contents
