Rules For Safe Operation - General International 80-250 Setup & Operation Manual

Rules for Safe Operation

To help ensure safe operation, please take a moment to learn the machine's applications and limita-
tions, as well as potential hazards. General® International disclaims any real or implied warranty and
holds itself harmless for any injury that may result from improper use of its equipment.
1. Do not operate this jointer when tired, distracted, or
under the effects of drugs, alcohol or any medica-
tion that impairs reflexes or alertness.
2. Keep the work area well lit, clean and free of debris.
3. Keep children and visitors at a safe distance when the
jointer is in operation - do not permit them to operate
the jointer.
4. Childproof and tamper proof your shop and all
machinery with locks, master electrical switches and
switch keys, to prevent unauthorized or unsupervised
use.
5. Do not wear loose clothing, gloves, bracelets, necklace
or ornaments. Wear face, eye, ear, respiratory and body
protection devices, as indicated for the operation or
environment. Wear protective hair covering to contain
long hair and wear non-slip footwear.
6. Stay alert! Give your work your undivided attention.
Even a momentary distraction can lead to serious
injury.
7. Be sure the blades have gained full operating speed
before beginning to cut.
8. Keep hands well away from blades and all moving
parts. Do not clear chips by hand - use a brush.
9. Do not force the jointer. It will perform better and safer at
the rate for which it was designed.
10. Whenever possible use a dust collector to minimize health
hazards.
11. Never leave the machine unattended while running
or with the power on.
12. If using a power feeder, stop the feeder before stop-
ping the Jointer.
13. Use recommended speed blades, accessories and
workpiece material.
14. Never stand on machinery. Serious injury could result
if the jointer is tipped over or if the blades are unin-
tentionally contacted.
15. Be sure blades are securely installed in the machine.
16. Keep guards in place and in working order. If a guard
must be removed for maintenance or cleaning be sure it
is properly re-attached before using the tool again.
17. Be sure that adjusting wrenches, tools and other
clutter are removed from the machine and / or the
table surfaces before starting the machine.
18. Use of parts and accessories not recommanded by
General International may result in equipment mal-
function or risk of injury.
19. Make sure tool is properly grounded. If tool is equip-
ped with three-prong plug, it should be plugged into a
three-pole receptacle. Never remove the third prong.
20. Always disconnect jointer from power source before
servicing or changing accessories such as blades, or
before performing any maintenance or cleaning.
21. Make sure that switch is in "OFF" position before plug-
ging in power cord.
22. Hold stock firmly against the table. Always feed stock
using push blocks or paddles.