Table of Contents
Advertisement
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
REMOVING THE CHUCK
A
1.
Using feed handle, lower the quill assembly A. In-
sert the drift key B all the way into the quill assem-
bly C.
INSTALLING A DRILL BIT
E
1.
Open the chuck by turning the key E counter-
clockwise until you can insert a drill bit F.
BASIC ADJUSTMENTS & CONTROLS
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG. RE-
PLACE DAMAGED CORD OR PLUG IMMEDIATELY. TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP , MAKE SURE
THE POWER SWITCH IS IN THE OFF POSITION BEFORE CONNECTING TO A POWER SOURCE.
CONNECTING TO A POWER SOURCE
Once the assembly steps have been completed, plug
the power cord into an appropriate outlet.
Refer back to the section entitled "Electrical Require-
ments" and make sure all requirements and grounding
instructions are followed.
When operations have been completed unplug the
machine from the power source.
16
C
B
F
2.
While holding onto the chuck, tap gently on the
key with a hammer or rubber mallet to loosen and
remove the arbor and chuck.
Note: It may be necessary to rotate the quill in order to be
able to get the tool all the way through D.
2.
Secure the drill bit in the chuck by turning the key
clockwise.
SWITCH OFF
TO AVOID UNEXPECTED OR UNINTENTIONAL
START-UP , MAKE SURE THAT THE POWER SWITCH
IS IN THE OFF POSITION BEFORE CONNECTING
TO A POWER SOURCE.
D
Hide quick links:
Advertisement
Table of Contents
