Installing The Chuck Guard; Installing The Downfeed Handles - General International 75-155 Setup & Operation Manual

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.

INSTALLING THE CHUCK GUARD

1. Slide the chuck guard onto its support as shown A.

INSTALLING THE DOWNFEED HANDLES

1.
Thread the three downfeed handles into their
mounting holes located in the support B.
INSTALLING THE SPEED CONTROL LEVER
1.
Thread the handle into its mounting hole located
in the bracket C.
14
A
B
C
2.
Tighten the chuck guard using a phillips screw-
driver.
2.
Tighten each handle using a 9 mm wrench.
2.
Tighten the handle using a 9 mm wrench.