General International 75-155 Setup & Operation Manual page 12

MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
INSTALLING THE TABLE (75-155/165)
5. Tighten the arm's mounting bolt using a 24 mm
wrench.
7. Lock the table in place by turning lever A clock-
wise.
9. Tighten the set screw E using a 4 mm Allen key.
12
A
E
6. Insert the table into the arm mount as shown.
C
B
8. Slide handle B onto the arbor C as shown D.
F
10. Lock the table in position by tightening the lever F
as shown.
D