Table of Contents
Advertisement
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
ON/OFF POWER SWITCH
This drill is equipped with a forced opening line interrupter switch located on the front which requires machine
restart in case of power failure or circuit interruption.
To start the machine, pull up the switch cover and press the start button "I", A.
To stop the machine, press directly on the switch cover B.
To turn on the laser pointer, set the swtich C in the "I" position. To turn off the laser pointer, set the switch in the "O"
position.
A
POWER ON
ADJUSTING THE CHUCK GUARD HEIGHT
1.
Loosen the wing nuts D.
ADJUSTING THE DEPTH STOP
This drill is equipped with an adjustable depth stop to allow repetitive drilling to a set depth. To set the depth stop:
E
1.
Loosen knob E counterclockwise as shown.
B
POWER OFF
D
2.
Position the shield at the desired height, then re-
tighten the wing nuts.
F
2.
Turn the depth stop to the desired drilling depth F,
then retighten the knob.
C
LASER POINTER SWITCH
17
Hide quick links:
Advertisement
Table of Contents
