MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
INSTALLING THE TABLE (MODEL 75-510 ONLY)
A
1.
Insert the threaded centering pin A into the small-
est hole of the table bracket as shown
3.
Slide the table onto the pin.
5.
Tighten the bolt with a wrench.
2.
Align the smallest mounting hole in the table with
the pin.
B
4.
While an assistant holds the table in position, insert
the bolt B into the large mounting hole.
6.
Thread nut C onto the centering pin and tighten
using a 13 mm wrench.
Note: To install the table crank handle, follow steps 8 to 9
in the previous section.
C
13