OPERATING INSTRUCTIONS
CHECKLIST BEFORE STARTING
VERIFY ALL CHECK POINTS BEFORE STARTING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURIES.
•
Make sure the pulley cover is closed.
•
Check that the chuck is installed properly.
•
Make sure the chuck guard is securely installed and closed properly.
•
When turning the machine "ON" be aware that the shaft will rotate freely.
•
When the drill press is running check to see if it runs without vibration or shaking.
•
Make sure the table bracket moves up and down smoothly.
•
Make sure the spindle shaft turns smoothly.
DRILLING STEP-BY-STEP
1.
Lift the chuck guard as shown and install a drill bit
suitable for the type of material to drill.
3.
Secure the workpiece in a vise (optional).
5.
Turn ON the machine and adjust the speed.
20
2.
Flip the chuck guard down in place as shown.
4.
For precision drilling use the laser pointer A to lo-
cate the drilling point on the workpiece.
6.
Use the downfeed handles to lower the bit into the
workpiece.
A