Advertisement
ATTACH THE BACK FENCE RAIL TO YOUR SAW
A
B
1.
Use 6 cap screws with lock washers and nuts A to assemble the rear rails to the rear of the saw as shown B.
C
2.
Make sure that the intersection C between the two rear rails is leveled D.
MOUNT THE SWITCH
A
B
1.
Temporarily remove the end cap from the left end of
the front rail A.
2.
Slide the heads of the bolts of the switch mounting
bracket into the t-sot on the underside of the fence
rail B.
D
(50-090RK / 50-090RC)
C
3.
4.
5.
(50-090RK / 50-090RC)
4»
Position the switch somewhere between 4» and 12»
from the end of the fence rail C, depending upon
your personal preference.
Tighten the screws to secure the switch in place.
Reinstall the end cap on the front rail.
5
Advertisement
