Connecting The Test Fixture With A Measuring Instrument - Keysight Technologies 16197A Operation And Service Manual

Installation Guide

Connecting the Test Fixture with a Measuring Instrument

Connecting the Test Fixture with a Measuring Instrument
Connecting the test fixture 16197A with a measuring instrument requires an
adapter suited to the instrument.
The test fixture 16197A is suitable for use with a high-frequency LCR meter or
an impedance analyzer.
Table 1-2 Adapter for a Measuring Instrument
Measuring
Instrument
E4991A
E4991B
E4982A
4294A, E4990A-120
E5061B-3L3/3L4/3L5
with Opt. 005
The test fixture 16197A can also be connected with any measuring instrument
with 4-terminal pair configuration if an appropriate adapter is used.
For the procedure for attaching an adapter, see the Operation Manual for the
adapter.
Calibration on the 7-mm connector surface may be necessary depending
on the type of measuring instrument. In such a case, perform calibration
on the 7-mm connector surface before connecting the test fixture with the
measuring instrument. For details, see the Operation Manual for the
measuring instrument.
Below is the general procedure for attaching an adapter to the test fixture. (For
details, see the Operation Manual for each adapter.
Keysight16197A Operation and Service Manual
Table 1-2
Adapter
Test head (supplied with the E4991A)
Test head (supplied with the E4991B)
Test head (supplied with the E4982A), Test Fixture Stand (Opt.
710) and 3.5mm- 7mm Coaxial Adapter (opt.720)
42942A terminal adapter
16201A
Step 1. Rotate the 7mm connector on the adapter counterclockwise as
viewed from above to completely retract the connecting sleeve.
Step 2. Gently place the test fixture onto the adapter, aligning the mounting
holes with the mounting posts on the adapter, and the 7mm
connector with that on the adapter.
shows possible adapter combinations.
13