Shdsl Network Termination Unit Authentication Error - Alcatel-Lucent 1643 AMS Operation Manual

Access multiplexer and access multiplexer small (formerly metropolis am and metropolis ams. release 1.0 through 7.2. alarm messages and trouble clearing guide
Hide thumbs Also See for 1643 AMS:
Table of Contents

Advertisement

Alarm messages

SHDSL Network Termination Unit authentication error

...................................................................................................................................................................................................................................
Alarm identifier
Information
Alarm category
ASAP
Alarm severity
(default setting)
Reporting state
(default setting)
Local indications
Cause
Actions
Note(s)
...................................................................................................................................................................................................................................
1-142
NTUcNAE
Interworking is not possible between the LTU and the respective NTU modem
which is connected at an SHDSL port of the LTU.
SHDSL Network Termination Unit authentication error
Note that the
alarm is applicable to NTU modems of type SDSL-NT10ETH only.
Equipment
sdsl
Deferred
Reported
No successful authentication could be achieved between the LTU and the NTU
modem.
Make sure that all SHDSL ports on the respective SDSL-NT10ETH modem are
connected with the same LTU.
Because the SDSL-NT10ETH modem is connected via a number of parallel
SHDSL interfaces, there is a possibility of misconnection. An NTU will only
accept configuration commands from a single LTU.
As a means to ensure that an NTU is communicating with a single LTU over
all its interfaces, the LTU sends a "signature" as part of the startup procedure,
after an attached SDSL-NT10ETH modem is detected.
The signature is sent in a special EOC-ext. message before any configuration
data are transmitted. In case the authentication is unsuccessful (for example, if
an NTU is connected with multiple LTUs; cf.
(p. 1-163)
– wiring error type III), then the NTU returns an error code (0xB1)
to the LTU. If, after 3 retries, the authentication still remains unsuccessful,
SHDSL Network Termination Unit authentication error
then an
is reported.
Alcatel-Lucent - Proprietary
See notice on first page
"Typical wiring errors"
alarm
365-312-803R7.2
Issue 4, May 2007

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1643 am

Table of Contents