Alarm messages
Q-LAN termination loopback failed
...................................................................................................................................................................................................................................
Alarm identifier
Information
Alarm category
ASAP
Alarm severity
(default setting)
Reporting state
(default setting)
Local indications
Cause
Actions
Note(s)
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
LANcTRM
Q-LAN is not terminated.
Processing error
dcn
Information
Not Reported
The red fault LED is flashing.
Q-LAN terminator loopback is interrupted.
•
Check cabling.
•
Check interface connections.
•
Check Q-LAN termination stubs.
•
Check the ITM-SC in the indicated network element.
This alarm only reports a loopback failure in the Q-LAN, therefore it should be
sufficient to check for hitches in the Q-LAN cable or check the reporting
SC-unit (which contains the Q-LAN device).
In general this alarm will only be reported on the ITM-CIT since the ITM-SC
will have lost association with the network element.
Alcatel-Lucent - Proprietary
See notice on first page
1-117