Shdsl Wiring Error - Alcatel-Lucent 1643 AMS Operation Manual

Alarm messages

SHDSL Wiring Error

...................................................................................................................................................................................................................................
Alarm identifier
Information
Alarm category
ASAP
Alarm severity
(default setting)
Reporting state
(default setting)
Local indications
Cause
Actions
Note(s)
Typical wiring errors
The following figures visualize typical types of wiring errors.
Wiring error type I
Two or more SHDSL connections are crossed:
Wiring error type II
An LTU port is connected to the wrong SDSL-NT10ETH:
...................................................................................................................................................................................................................................
365-312-803R7.2
Issue 4, May 2007
SDSLcSWE
Between the SHDSL ports on the LTU (1643 AM/ 1643 AMS) and the SHDSL
ports on the NTU modem, an incorrect wiring of cables has been detected.
SHDSL Wiring Error
Note that the
type SDSL-NT10ETH only.
Equipment
sdsl
Prompt
Reported
–
LTU and NTU ports are connected incorrectly.
Correct the wiring of cables such that the rules for connecting LTU and NTU
ports are observed.
The NTU ports can be connected to the LTU ports in any order, as long as
newly connected ports are adjacent to the already used port (or group of ports)
on the LTU, and numerically incrementing port numbers on the NTU are
connected to numerically incrementing port numbers on the LTU.
Typical wiring errors are shown subsequent to this table.
LTU
®
Metropolis AM/AMS
Alcatel-Lucent - Proprietary
See notice on first page
alarm is applicable to NTU modems of
NT10ETH
1-163