Alarm messages
STM-1 interface extension board failure
...................................................................................................................................................................................................................................
Alarm identifier
Information
Alarm category
ASAP
Alarm severity
(default setting)
Reporting state
(default setting)
Local indications
Cause
Actions
Note(s)
...................................................................................................................................................................................................................................
1-166
STM1XcUPF
STM-1 interface extension board failure
Equipment
equipment
Prompt
Reported
The red "Fault" LED is lit.
A hardware failure of the STM-1 interface extension is detected.
Remove the STM-1 interface extension board and replace it with another one.
As 1643 AM and 1643 AMS systems do not support hardware protection,
STM1XcEQF, and STM1XcUPF are always reported simultaneously as a
reminder that a hardware failure is service affecting.
Alcatel-Lucent - Proprietary
See notice on first page
365-312-803R7.2
Issue 4, May 2007