Image Send Settings; Operation Settings; Default Display Settings; Address Book Default Selection - Sharp MX-M1100 User Manual

Image Send Settings

Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings]
key to configure the settings.
For explanations of settings related to the fax function, see
(page 76).

Operation Settings

The operation settings below apply to all image send functions.
Other Settings

Default Display Settings

You can select one of 5 base screen types for the base
screen that appears when the [IMAGE SEND] key is
touched or when the [CLEAR ALL] (
in image send mode.
• Address Book
• Scan
• Internet Fax
• Fax
• Data Entry
Hold settings for a while after scanning has been completed
Use this setting to hold the settings after scanning is
completed (until Auto Clear Mode activates).
Switch Automatically to Copy Mode Screen
Enable this setting to have the screen automatically
switch to the copy mode screen if no action is taken in
the image send mode screen for 20 seconds.

Address Book Default Selection

One of the following screens can be specified for the
initial address book screen.
Tab Switch
• ABC
• Group
Address Type
• All
• E-mail
• FTP/Desktop
• Network Folder
• Internet Fax
• Fax
• Group
"2. SYSTEM SETTINGS FOR FAX
) key is pressed
53
Initial Resolution Setting
The following settings are available for the default
resolutions of scan, Internet fax, and fax mode.
Scan : 100X100 dpi, 200X200 dpi, 300X300 dpi,
400X400 dpi, 600X600 dpi
Internet fax : 200X100 dpi
200X200 dpi
200X400 dpi
400X400 dpi
600X600 dpi
Fax: Standard
Fine
Super Fine
Ultra Fine
Apply the Resolution Set when Stored
When an image stored by document filing is used, this
applies the resolution setting that was stored with the
image.
(ADMINISTRATOR)"
Half Tone
Half Tone