Device Control; Other Settings; Auto Paper Selection Setting; Saddle Stitch Position Adjust - Sharp MX-M1100 User Manual

Device Control

These settings control devices installed on the machine. Touch the [Device Control] key to configure the settings.

Other Settings

Original Feeding Mode
The following original feeding modes can be set to
operate by default in copy, Scan to HDD, and image
send modes. When a mode is frequently used, this
saves you from having to select the mode in the special
modes each time you need to use it.
• Mixed Size Original (Same Width/Different Width)
• Slow Scan Mode

Saddle Stitch Position Adjust

(When a saddle stitch finisher or saddle unit is
installed.)
This setting is used to adjust the stapling position
(folding position) of the pamphlet staple function.
The value can be adjusted in increments of 0.2 mm
within a range of ±3.0 mm from the home position of
each paper size.
Max. + 3 mm
Position moved in
the plus direction.
1
2
Reference position
Depending on the saddle unit / saddle finisher settings
in "Option Adjustment" (page 75) (saddle stitch
position, folding position), adjustment within ±3 mm
may not be possible.
Min. - 3 mm
Position moved in
the minus direction.
12
11

Auto Paper Selection Setting

The paper types* that the Auto Paper Selection function will
select can be specified. Select one of the following settings:
• Plain Paper
• Plain and Recycle Paper
• Recycle Paper
The Auto Paper Selection function will not select any
paper types other than the paper types specified with
this setting.
* The paper type set for each paper tray using "Paper
Tray Settings" in the system settings.
Tandem Connection Setting
When two machines are used as network printers using
TCP/IP protocol, use this setting to configure the port
number and IP address of the machine used as the
tandem slave machine.
Disabling of Master Machine Mode
To prohibit tandem transmission, enable this setting.
(There is normally no need to enable this setting.)
Disabling of Slave Machine Mode
To prohibit tandem reception, enable this setting. (There
is normally no need to enable this setting.)
• The factory default setting for the port number is
[50001]. Unless you experience difficulty with this
setting, do not change the port number.
• To use the tandem function when user
authentication is enabled, the same login name and
password must be used on both the master
machine and slave machine. If the same login name
and password are not used, the page count may not
be added to the appropriate user count or only the
master machine may print.
42