Sharp MX-M1100 User Manual page 421

Select the special modes.
If the base screen is not displayed, touch the [Condition Settings] key.
(1) Make sure that the desired mode is selected.
If the desired mode is not selected, touch the tab of that mode.
(2) Touch the [Special Modes] key.
3
(3) Touch the [Suppress Background] key.
Read the message that appears and then touch the [OK] key.
☞
SPECIAL MODES
When you return to the base screen after specifying the destination, the base screen of the mode of the specified
destination appears.
Scan/Special Modes
Suppress Background
Light areas of the original may be suppressed as background.
4
1
Press the [START] key (
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
When scanning finishes, place the next original and press the [START] key (
scanned and then touch the [Read-End] key.
5
A beep will sound to indicate that scanning is finished.
When the original is scanned in [Mono2], the suppress background function will not operate.
To cancel scanning...
Press the [STOP] key (
To cancel the background suppression setting...
Touch the [Cancel] key in the screen of step 4.
(page 87)
(1) (2)
Cancel
3
).
) to cancel the operation.
Select the suppress background setting.
(1) Adjust the background suppression level.
OK
Touch the [+] key to suppress only faint background.
OK
Touch the [-] key to suppress faint to dark background.
(2) Touch the [OK] key.
101
). Repeat until all pages have been