Adding And Configuring The Virtual Channel Driver - LC Packings SWITCHOS II User Manual

4.2.4
To monitor and record various parameters of the UltiMate (e.g. the column
pressure or the oven temperature) a Virtual Channel Driver is needed.
To add a Virtual Channel Driver:
a) Click on Add Device in the Server Configuration box and select Virtual
Channel Driver from the General tab to present the Virtual Channel Driver box
(FIGURE 4-5).
FIGURE 4-5
b) Check the first channel and click on Change to configure it. To readout the
column pressure, configure the Signal Configuration box as indicated in
FIGURE 4-6.
FIGURE 4-6
To monitor other parameters (e.g. the UltiMate Micropump pressure), select a
new channel (FIGURE 4-5) and configure the signal as presented in TABLE 4-2.
User's Manual Switchos II

Adding and Configuring the Virtual Channel Driver

The Virtual Channel Driver Box
Virtual Channel Setup for Column Pressure Readout
D850R3
Software Control
4-5