Alternative Method For Lifting The Dispenser - High Hose; Anchoring The Dispenser To The Island - Bennett 3700 Series Installation Manual

Lifting a New Dispenser and Placing it on the Island
Lifting the Dispenser from Above - On the high hose models, there are lifting brackets provided in the
upper area of the dispenser. There is a cover that has to be removed to access these brackets. (See
figure 5 and figure 6 below).
Figure 5 - Cover is screwed onto the top of the dispenser
and must be removed to access the lifting brackets.

Anchoring the Dispenser to the Island

The dispenser must be bolted firmly to the concrete island. The dispenser base is provided with anchor
bolt holes (see base drawings in back of this manual for dimensions). Anchor bolts embedded in the
concrete island must be not less than ½" diameter. The threaded ends of the anchor bolts should
project 1-1/2" above the concrete.
On the Low Hose dispenser, 2 anchor bolts required minimum.
On the High Hose dispenser, 4 anchor bolts required minimum in the outer 4 mounting holes.
Refer to the Footprint Drawings in the back of this manual for hole locations.
When anchoring the dispenser, always level the dispenser with shims before bolting to the island. Place
the shims at the location of the anchor bolts so the dispenser frame is not distorted when the anchor
bolts are tightened down.
Alternate Method for High Hose
Figure 6 - After the top cover is removed, the lifting brack-
ets can be accessed for lifting the dispenser from above.
14
120001 Rev K 1-19-18