KaVo ORTHOPANTOMOGRAPH OP 3D User And Installation Manual page 17

IMAGING PROGRAM SETTINGS:
Test mode
Patient size
End Study
STATUS MESSAGE BAR:
Device status indicator
ORTHOPANTOMOGRAPH
Indicates if Test mode is active.
Press Test mode icon to disable/enable device radiation production.
This mode can be used for example to demonstrate the device
movements.
You can also use the positioning panel to activate the Test mode.
Indicates the currently selected patient size preset.
Press the Patient size selection icon to open a list of patient sizes;
Small, Medium & Large.
Press on the listed patient size icon to activate it.
Selecting a patient size, according to the scanned patient, adjusts
the kV and mA to preset levels.
NOTICE! Patient size presets can be adjusted from settings
menu.
Press End Study icon to finalize the imaging procedure and return to
the main view.
Status message bar shows the device status with a colored Device
status indicator.
• Green: Device is ready for imaging.
• Gray: Device is not ready for imaging, follow the instructions on
the status message bar.
• Yellow: Imaging process ongoing.
• Blue: Device in error state or pending user action.
™
OP 3D
4 User Interfaces
17