Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual page 12

Mechanical Installation
3 3
Illustration 3.3 Recommended Lifting Method, Enclosure Size
F11/F12/F13/F14.
NOTICE
The plinth is provided in the same packaging as the
frequency converter, but is not attached during
shipment. The plinth is required to allow airflow cooling
to the frequency converter. Position the frequency
converter on top of the plinth in the final installation
location. The angle from the top of the frequency
converter to the lifting cable should be >60°.
In addition to Illustration 3.1 to Illustration 3.3, a spreader
bar can be used to lift the frequency converter.
10
Operating Instructions
Danfoss A/S © Rev. 06/2014 All rights reserved. MG20Y202