Disabling The Control Knobs; Output Gain Adjustment - Burmester 099 Owner's Manual

Disabling the control knobs To prevent unwanted use of the 099 preamplifier the control knobs on the front panel

Output gain adjustment

may be disabled. The unit will then only respond to the POWER switch. The 099 can
now be controlled by remote only. This serves as child safety for example.
Turn the Input selector knob (5) or press the ► ◄ buttons on your remote until the
TAPE LED in the row of Input selection LEDs (1) goes dark while all other LEDs
are illuminated (see chart).
By turning the Volume control knob (7) or by pressing the ▲ ▼ buttons on the
remote you can now activate or deactivate this option. When the control knobs are
enabled the center LED of the Volume level LEDs (4) is illuminated.
To exit the menu, simply press the MENU button on your remote.
If you are operating the preamplifier with power amps or active speakers with low
input sensitivity you may boost the maximum overall gain by +6dB.
The adjustment is done in the menu under the AUX menu option. Turn the Input
selector knob (5) or press the ► ◄ buttons on your remote until the AUX LED in
the row of Input selection LEDs (1) goes dark while all other LEDs are illuminated
(see chart).
By turning the Volume control knob (7) or by pressing the ▲ ▼ buttons on the
remote you can now activate or deactivate this option. When the high-gain option
has been activated the center LED of the Volume level LEDs (4) is illuminated.
To exit the menu, simply press the MENU button on your remote.
18