Troubleshooting - Burmester 099 Owner's Manual

The 099 does not power up
Have you set the AC mains switch to ON?
-
The POWER LED is blinking green. This indicates either a defective fuse F1 or that the voltage supplied by
-
your AC outlet does not conform to standards. Please contact your authorized dealer.
The POWER LED is blinking orange. This indicates that a fuse in your 099 is defective.
-
The unit is switched on but I cannot change the volume
Most likely the SETUP MENU function has been activated. If both the AUDIO and the PHASE LEDs are
-
blinking you can exit the SETUP MENU function by pressing the MENU button on your remote control.
- If you have selected the USB interface as input make sure the volume level in your PC is not set to 0.
Why do some input LEDs blink and others do not?
All digital inputs blink when they do not detect a usable signal at the input terminal. This way the unit
-
indicates if it receives correct digital data at the input. In other words, the input LED on the front panel starts
blinking if a digital input has been selected without the corresponding terminal on the rear panel being
connected to a source. Hence, the blinking is normal operating procedure.
I cannot activate the fixed output level
- To avoid the accidental setting of a fixed output level that may damage your power amp or active speakers
the fixed output level setting has to be confirmed with a code. You will find the details how to do it in the
chapter SETUP MENU.
I cannot switch the unit on and the POWER LED is blinking orange
The power supply is unable to provide voltage to the main transformer. Using the AC Mains switch (11)
-
turn the 099 off and wait for app. 30 seconds before turning it back on. If nothing happens try it again. If the
error persists it is most likely that one of the fuses is defective. Please contact your authorized dealer.
The 099 does not play back music via USB port
Please check the USB cabling and connection.
-
Please check if the 099 is set as the active sound device in your computer's operating system.
-
Make sure that the volume of the operating system and the software music player is not set to zero.
-
Please use a music player software on your computer to play music via the 099 sound device.
-
Make sure that the operating system of your computer is able to handle the desired USB audio class. Try to
-
adjust the audio class by longer pressing the Audio button on the remote control.

TROUBLESHOOTING

10