Burlink; Connections; Commands - Burmester 099 Owner's Manual

The BURLINK interface can be accessed either by the 9-pin D-SUB port (RS-232) (12) or by the USB port (13).
Configuration of RS-232: 9600Baud, 8Bit, Parity: none, 1Stoppbit, and no hardware handshake.
Before using the USB port the appropriate drivers must be installed. The software for the USB port is compatible with
the operating systems WINDOWS 2000 and WINDOWS XP.
All necessary commands to control the 099 preamplifier are listed below. The commands must be sent in capital
letters and each command must end with a „carriage return" \r.
POWON\r
POWOFF\r
INP+\r
INP-\r
INP1\r
INP2\r
INP3\r
INP4\r
INP5\r
INP6\r
INP7\r
INP8\r
INP9\r
VOLUP\r
VOLDN\r
VOLxx\r
PHASE\r
PHASE180\r
PHASE0\r

BURLINK

CONNECTIONS

COMMANDS

switches the 099 on
switches the 099 into Standby mode
activates the inputs in rising sequence
activates the inputs in falling sequence
activates the Tuner input
activates the Tape input
activates the Aux input
activates the CD input
activates the DVD input
activates the TV input
activates the SAT input
activates the NET input
activates the USB port
raises the volume by one increment
lowers the volume by one increment
adjusts the playback volume to a fixed level xx (from 00 to 63)
switches the phase of the activated input between 0˚ and 180˚
inverts the phase of the activated input to 180˚
inverts the phase of the activated input to 0˚
20