Detailed Error Information - Omron SYSMAC 3G8F7-CLK13-E Operation Manual

Detailed Error Information

Disconnected Node Information
Starting Time for Disconnected Information Storage
4-3

Detailed Error Information

High Bits
Disconnection Direction Flag
0: SL1 (upstream)/Normal
1: SL2 (downstream)
Low Bits
Disconnected Node Address (2-digit hexadecimal)
Disconnected node information can be read out for up to two disconnections:
Disconnected Node Information 1 and Disconnected Node Information 2.
The time when recording disconnection information was started is stored as
shown above. All data is BCD.
The information read by ClkGetLastError is listed in the following table. Macro
names for error codes are defined in CLK_LIB.H.
Error Macro name
code
1 ERR_UNIT_ADDRESS
2 ERR_NO_CLKUNIT
3 ERR_NO_MEMORY
4 ERR_MSG_SIZE_OVER
5 ERR_NO_MEM_TYPE
6 ERR_RESPONSE
7 ERR_SEND_BUFFER_SIZE
8 ERR_RECV_BUFFER_SIZE
9 ERR_WRITE_BUFFER_SIZE
10 ERR_READ_BUFFER_SIZE
11 ERR_WINDOWHANDLE_PARA
12 ERR_MESSAGE_PARA
13 ERR_MEMORY_AREA
14 ERR_INTERNAL_FAILURE
15 ERR_NOT_RING_MODE
16 ERR_NETWORK_ADDRESS
30 ---
31 ---
32 ---
33 ---
Bit
[0]
Minutes
[1]
Seconds
[2]
Date of month
[3]
Hour (24-hr time)
[4]
Year (rightmost 2 digits)
Month
[5]
Unit address range error
Controller Link Unit is missing.
Memory could not be obtained.
Reception message was too large.
Memory type does not exist.
Response code error
Send message size error
Reception message size error
Write data size error
Read data size error
Window handle error
Message type error
Memory type designation error
Unexpected error
Not in Optical Token Ring Mode.
Network address designation error
Service not defined.
Incorrect network handle
Memory insufficient; cannot execute.
Unit of the same unit address already
exists.
Section 4-3
Meaning
69