Omron SYSMAC 3G8F7-CLK13-E Operation Manual page 118

Commands and Responses for the Support Board
Note
98
Status 2 (response): This byte contains the following information for Control-
ler Link Support Boards. (It is always 00 Hex for Wired Controller Link Support
Boards.)
Bit
7 6 5 4 3 2 1 0
Baud rate setting
0001: 2 Mbps
0010: 1 Mbps
0011: 500 Kbps
Status 3 (response): Error information. The configuration is as follows:
7
Bit
1: Error log exists
1: Data link error stop
1: Controller transmitter error
A network parameter error occurs if the registered network parameter con-
tents do not match the actual network parameter contents after the power is
turned on. The system, however, will not stop. When a network parameter
error occurs, the actual network parameter contents are automatically regis-
tered to that Unit.
Status 5 (response): Error information related to the Support Board and the
PC. The configuration is as follows:
Bit
1: EEPROM error
1: PC model error
(C200HX/HG/HE only)
1: PC system setting error
(CV-series PCs only)
A network parameter error, data link table error, or routing table error occurs if
an error is discovered when the parameters and tables are checked at power
up.
A PC system setting error occurs if the Controller Link Unit is not properly rec-
ognized by a CS-series, CJ-series, or CV-series PC.
A PC model error occurs if a C200HX/HG/HE Controller Link Unit is mounted
to another type of PC.
Count 1 to Count 8 (response): The total number of times for each of the
items listed below is returned as 1 byte of hexadecimal data.
Count 1: Number of CRC errors
Count 2: Number of token re-sends
Count 3: Number of token returns
Count 4: Number of token timeouts
Count 5: Number of polling timeouts
Count 6: Number of controller changes
Count 7: Number of active node changes
Count 8: Reserved for system use.
0 0 0
Wired System
0: Terminating resistance switch OFF
1: Terminating resistance switch ON
Optical System
0: No backup power supply
1: Backup power supply
6 5 4 3 2 1 0
0
1: Node address setting error
1: Duplicate node address setting error
1: Network parameter error
1: Controller hardware error
7 6 5 4 3 2 1 0
0 0
1: Network parameter error
1: Data link table error
1: Routing table error
Section 6-3