How To Enter Passcodes - Magtek DynaPro Go Installation And Operation Manual
Handheld pin pad device with msr/contact/contactless
Hide thumbs
Also See for DynaPro Go:
- Programmer's manual (247 pages) ,
- Installation and operation manual (77 pages) ,
- Quick installation manual (4 pages)
Table of Contents
Advertisement
6 - Operation
6.9
How to Enter Passcodes
Some device operations require the operator to enter a passcode before the operation can proceed. In
these cases, the device's display will prompt the user to
. The operator should
Enter Admin Passcode
enter the passcode (the factory default is
) and press
. The device shows asterisks
8765432
Enter
masking the passcode the operator is entering. If the operator makes a mistake, the
button clears
Clear
the passcode field so the operator can start over, and the
button cancels the operation that
Cancel
required the passcode.
Figure 6-24 - Passcode Prompt Screens
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 55 of 60 (D998200129-10)
Advertisement
Table of Contents
Need help?
Do you have a question about the DynaPro Go and is the answer not in the manual?
Questions and answers