How To Power On / Power Off; Battery Warnings And Automatic Power Off - Magtek DynaPro Go Installation And Operation Manual

6 - Operation

6.3.2 How to Power On / Power Off

To power on the device, press and hold the
screen and the current device status (see section 6.2 How to Read Device Status).
display the
Welcome
To power off the device, press and hold the
for two seconds to display a
button
right function keys. To power off, press the function key below
to the screen, either wait 10 seconds or press the function key below
Welcome
powering off, the display shows

6.3.3 Battery Warnings and Automatic Power Off

When the battery is running low, the device will show
your device to a power source
that the device can no longer function properly, the device attempts to complete any pending transaction,
then shows
Device is powering off ... Battery critically low
automatically. See section 6.3.1 How to Charge the Battery for details on recharging.
Figure 6-10 – Battery Level is LOW Warning / Battery Critically Low
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Power button
Power button
screen with a
Power Off?
for three seconds before the display goes blank.
Powering off...
Warning: Battery Level is LOW... Connect
on the screen. When the battery is discharged to the point
Welcome
Page 43 of 60 (D998200129-10)
for one second. Upon powering up, it will
for seven seconds, or press the
/ selection above the left and
Yes No
. To cancel powering off and return
Yes
No
for three seconds before powering off
Power
. While the device is