How To Connect Dynapro Go To A Host Via 802.11 Wireless - Magtek DynaPro Go Installation And Operation Manual

Handheld pin pad device with msr/contact/contactless

Hide thumbs Also See for DynaPro Go:

Table of Contents

4 - Installation

5) When connecting to some hosts, Windows may show an error message reporting

[software] was not successfully installed

device may work immediately; if not, disconnect the device from the USB port, then re-connect it.

6) The device will show the USB Connected symbol at the top of the display (see section 6.2 How to

Read Device Status).

4.3.2 How to Connect DynaPro Go to a Host via 802.11 Wireless

To connect DynaPro Go to a host computer or charger using the 802.11 wireless connection, follow these

steps:

1) Make sure the wireless access point, network, device, and host are set up properly and tested

according to the steps in section 5.4 How to Configure Network Settings (ADVANCED).

2) Power on the device and make sure the device is configured to use the 802.11 wireless connection

according to the steps in section 5.3 How to Change the Active Connection.

3) Make sure the device is connected to the wireless network by checking the status icons. For details,

see section 6.2 How to Read Device Status.

DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual

Device unplugged

Page 21 of 60 (D998200129-10)

Device driver

. The error is harmless and the

Table of Contents

Do you have a question about the DynaPro Go and is the answer not in the manual?