Magtek DynaPro Go Installation And Operation Manual page 32

5 - Configuration
16) Press the device's power button for two seconds to turn it off, and use the function keys to select
. The device will reboot because USB is attached.
Yes
17) Change the Active Connection to 802.11 Wireless (see section 5.3 How to Change the Active
Connection).
18) The screen will show a flashing wireless network icon at the top (see section 6.2 How to Read
Device Status).
19) Press
Left function key
20) The device will show a page about the 802.11 wireless connection. Write down the
press the key to close the screen.
Cancel
21) The device is now configured for hosts to connect to it using the wireless access point.
22) Test the connection between the device and the host:
a) If the host software is already configured, follow the steps in section 4.3.2 How to Connect
DynaPro Go to a Host via 802.11 Wireless.
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
, , , ,
7 8 3 Right function key
Page 32 of 60 (D998200129-10)
.
and
IP Address