How To Start A Handheld Wireless Transaction - Magtek DynaPro Go Installation And Operation Manual

Handheld pin pad device with msr/contact/contactless

Hide thumbs Also See for DynaPro Go:

Table of Contents

6 - Operation

6.4

How to Start a Handheld Wireless Transaction

When the device and host are configured for handheld operation using Device-Initiated mode, an

operator can start a transaction from the device by following these steps:

1) Make sure the device is connected to a wireless access point and has good signal strength (see section

6.2 How to Read Device Status).

2) Press

Left Function Key 1 2 3 Right Function Key

that it wants to initiate a transaction.

3) Depending on how the host software is designed, the host will send various messages requesting that

the cardholder or operator enter additional information, then the device will request payment in the

same way as section 6.5 Card Reading.

4) If there is no network activity or user interaction for 30 seconds, the device will close the wireless

connection automatically. If this occurs, the host should cancel the transaction and the operator

should repeat these steps to initiate the transaction again.

DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual

. The device will send a signal to the host

Page 46 of 60 (D998200129-10)

Table of Contents

Do you have a question about the DynaPro Go and is the answer not in the manual?