Attaching The Chassis To The Rack - San768C-6 Chassis - IBM SAN192C-6 Installation, Service And User Manual

Figure 34. Attaching the Chassis to the Rack - SAN768C-6 Chassis
1. Handles used to adjust the chassis placement
2. Nine M6 x 19 mm or 10-24 x 3/4 in. Phillips screws used to attach each
side bracket to a front mounting rail (use a total of 18 screws)
8. If you removed any fabric modules before moving the chassis, replace each
one in the chassis as follows:
a. Holding the front of the fabric module (the side with the LEDs), turn the
module so that the front side is vertical.
Note: The top of the module has an alignment bracket running from the
rear to the front. The electrical connectors will be at the bottom.
b. Align the rear of the fabric module to an open fabric slot and insert the
bracket on top of the module into the track at the top of the slot.
Chapter 3. Installing the IBM c-type SAN Device
69