Figure 20. SAN384C-6 Grid-PSU Connections
Figure 21 shows how to connect power supplies in a SAN192C-6 for grid
redundancy
Figure 21. SAN192C-6 Grid-PSU Connections
Supported Transceivers
The SAN384C-6 supports the Fibre Channel SFP+ transceivers in either SWL or
LWL.
Fibre Channel SFP+ Transceivers
The transceivers are field-replaceable and hot-swappable. You can use any
combination of SFP+ transceivers that are supported by the switch. The only
restrictions are that SWL transceivers must be paired with SWL transceivers, and
LWL transceivers with LWL transceivers, and the cable must not exceed the
stipulated cable length for reliable communications.
For more information about a specific SFP+ transceiver, see the "SFP+ Transceiver
Specifications" on page 107. SFP+ transceivers can be ordered separately or with
the IBM c-type SAN switches and directors.
Note: Use only Cisco transceivers in the IBM c-type SAN switches and directors.
Each transceiver is encoded with model information that enables the switch to
verify that the transceiver meets the requirements for the switch.
40
SAN192C-6, SAN384C-6 and SAN768C-6 Installation, Service, and User Guide