Sfp+ Transceiver Specifications; Fibre Channel Sfp+ Transceivers; Fibre Channel Transceivers - IBM SAN192C-6 Installation, Service And User Manual

SFP+ Transceiver Specifications

The IBM SAN c-type Directors are compatible with SFP+ transceivers and cables
that have LC connectors. The wavelength of each transceiver must match the
transceiver on the other end of the cable, and the cable must not exceed the
stipulated cable length for reliable communications.
SFP+ transceivers provide the uplink interfaces, laser transmit (Tx) and laser
receive (Rx), and support 850 to 1610 nm nominal wavelengths, depending upon
the transceiver.
Use only Cisco SFP+ transceivers on the SAN c-type Directors. Each SFP+
transceiver is encoded with model information that enables the switch to verify
that the SFP+ transceiver meets the requirements for the switch.
This section provides the following topics:
v "Fibre Channel SFP+ Transceivers"

Fibre Channel SFP+ Transceivers

Table 30 lists the Fibre Channel transceivers.
Table 29. AC PSU Requirements for Grid Redundancy (continued)
Platform
SAN768C-6
Table 30. Fibre Channel transceivers
Description
32 Gbps Fibre Channel SW SFP+
32 Gbps Fibre Channel LW SFP+
16 Gbps Fibre Channel SW, SFP+
16 Gbps Fibre Channel LW, SFP+
8 Gbps Fibre Channel SW, SFP+
8 Gbps Fibre Channel LW, SFP+
8 Gbps Fibre Channel ER SFP+
Configurations
Up to 16 x SAN c-type 48
Port 32 Gbps Fibre Channel
Switching Modules
Up to 12 x SAN c-type 48
Port 32 Gbps Fibre Channel
Switching Modules and up
to 4 x 24/10 port SAN
Extension Module
Any other supported module
or a combination of
supported modules:
v 48 Port 32 Gbps Fibre
Channel Switching
Module
v 24/10 port SAN Extension
Module
Type
Short wavelength
Long wavelength
Short wavelength
Long wavelength
Short wavelength
Long wavelength
Extended Reach
Appendix A. Product Specifications
Minimum PSUs Required
for Grid Redundancy
8
8
12
107