Verify The Shipment; Installing A 19-Inch Rack Mount Kit (Optional) - IBM System Storage TS2230 Setup, Operator, And Service Manual

1. Inspect the unit for shipping damage. If there is damage, do not install the unit.
2. Locate the label on the rear panel of the unit with the machine type, model

Verify the Shipment

Ensure that the following items are included in the shipment:
v Power cord (For the appropriate cord for your country or region, see
v IBM LTO Ultrium Cleaning Cartridge
v Single-connector SAS wrap tool
v Optional Rack Mount Kit
v The IBM System Storage TS2230 Tape Drive Quick Reference (GC27-2276-01)
v The IBM System Storage TS2230 Tape Drive Setup, Operator and Service Guide
v Documentation CD (includes library documentation, translated safety
v SAS cables are not part of the ship group. They must be ordered separately.

Installing a 19-inch rack mount kit (optional)

Important: Before installing the rack shelf, read the information on rack safety. See
Before you begin, read these instructions to familiarize yourself with the
installation procedure.
Verify Kit Contents
Tools Required
v 7 mm nut driver or 7 mm socket wrench
Installing a 19-inch rack shelf
1. Decide at what level you want to install the shelf. The drive requires 3 units
2-2
TS2230 Tape Drive Setup, Operator and Service manual
Report the damage immediately by contacting your place of purchase.
number, and serial number of the unit. Make a note of these numbers and store
them in an easily accessible place. Should you need to contact Technical
Support, you will be asked for these numbers.
Appendix C, "Ordering Optional Features, Replacement Parts, Power Cords, and
Media," on page C-1.)
GC27-3903-00 (this guide)
information, and translated warranty information
"Rack Safety" on page xiii
Qty Description
1 fixed shelf
4 screws
2 tie wraps
1 PDU line cord
Installation Instructions (Feature 7003)
(EIAs) of rack space (see 2 in Figure 2-1 on page 2-3).
Note: All vertical rack measurements are given in rack units (U). One U is
equal to 4.45 cm (1.75 in.). The U levels are marked on labels on one
front mounting rail and one rear mounting rail.