Local Parameter Config; Local Config - Dahua Modular VTO User Manual

Parameter
MGT Centre IP
Address
MGT Port No.
Register to the
MGT Centre
Call VTS Time
Call VTS or Not
No Answer
Transfer MGT
Centre
Click "OK" to save the settings.
Step 3
7.7

Local Parameter Config

7.7.1 Local Config

Set info about the device, such as device type and reboot date.
Select "System Config >Local Config> Local Config".
Step 1
The system displays "Local Config" interface, as shown in Figure 7-27.
Description
Index".
If call key of the camera has been bound with master VTH, press the

call key to make a call.
If VTO has been connected with button module and bound with

master VTH, press the call key to make a call.
If VTO has been connected with keyboard module, dial room no. of

master VTH to make a call.
 After group call function is enabled or disabled, the device reboots
automatically, so the configuration takes effect.
 To realize group call, VTH and VTO shall be set. Please refer to
"6.1.3 Group Call".
Set "MGT Centre IP Address" and "MGT Port No."; tick "Register to the
MGT Centre". VTO is registered to management centre, so management
centre can manage the VTO and VTH, and call VTH.
Please obtain management centre info in advance.
Ensure that VTO has been registered at management centre.
Set "Call VTS Time" and tick "Call VTS or Not". Press the call key on the
VTO within the set time period, to call the management centre only.
Tick "Enable" to enable transferring to management centre in case of no
answer.
In the following cases when VTO calls VTH, the system will transfer the
call to management centre automatically.
 SD card has not been inserted into VTH.
 SD card has been inserted into VTH, but VTO message time is set
to be 0 on the VTH.
Table 7-6
67