Basic Function; Call Function; Call Management Centre - Dahua Modular VTO User Manual

6.1

Call Function

6.1.1 Call Management Centre

The system provides different calling ways depending on connected module.
If modular VTO connects keyboard module, press

management centre.
 If keyboard module is not connected, press call key of camera module to call the
management centre.
Configure the following parameters before calling.
Select "System Config >LAN Config".
Step 1
The system displays "LAN Config" interface.
Select "Register to the MGT Centre"; set "MGT Centre IP Address" and "MGT Port
Step 2
No.".
Register the VTO at management center.
To call from keyboard module, ensure that VTO has been registered at

management centre.
To call by pressing the call key of camera module, it is necessary to enable "Call

VTS or Not".
Set "Call VTS Time" and select "Call VTS or Not".
Step 3
Enable to call the management centre within the set time period.
Click "OK" to save the settings.
Step 4
6

Basic Function

on the keyboard module to call the
37