Signal Indicator Chart; Digital Audio Selector Menu; Scenes - Lightware MMX8x4-HT Series User Manual


  
5. Software Control – Lightware Device Controller
Equalization (EQ) setting example
LOW LMID
dB
-18 dB +9
18
9
0
-9
-18
20 100 400
(Frequency)
Original curve
Frequency response curve
This example shows how EQ settings affect to the audio signal:
-18 dB was set for the LOW frequencies;
▪
▪ +9 dB was set for the LOW-MID frequencies;
▪ +3 dB was set for the HIGH-MID frequencies;
0 dB was set for the HIGH frequencies;
▪
TIPS AND TRICKS: Adjust the Low, Low-mid, High-mid, High values
to 0 is recommended as the first step of the EQ settings. Pursue
apply minimal modification of the original signal.
5.7.4. Signal Indicator Chart
This section gives a feedback about the actual level of the audio
signal:
In microphone input and advanced analog audio input channel,
▪
the displayed status depends on the actual level of the input
signal and the gain setting.
In the embedded audio channel, it depends on the actual level
▪
of the input signal.
▪ In case of the advanced analog output, it depends on the actual
level of the three audio signals (mic in, advanced audio input,
embedded audio), gain settings, and the input volume settings.
Left circle refers to the left channel, right circle to the right channel.
Signal indicator lights up when the signal level is above:
HMID HIGH
dB +3 dB
0 dB
5.7.5. Digital Audio Selector Menu
1.6k 8k 20k
Hz
The drop-down menu can be seen in the
layout of embedded input channel. This is
for selecting the digital audio channel. This
setting affects to the crosspoint, it connects
the chosen input to the analog audio output
(O5).

chosen (it was locked).
5.7.6. Scenes
8 memory slots are available to save all audio
properties of the audio mixer (Settings of Mic In, Audio
In, Embedded or Aux In and Audio Out Channel).
MMX8x4-HT series – User's Manual
Explanation Displays a recommended setting
Take care that peak led (PK!) never
PK!
PK! (Peak)
lights up!
NOM.
NOM. (Nominal) Occasionally lights up.
SIG.
Continuously lights (If it does not
SIG. (Signal)
light, signal level is too low.)
ATTENTION! Take care that peak led (PK!) never lights up!
Lock icon shows that the port can not be
Save a scene
Step 1. Do the required configuration in the advanced audio window.
Step 2. Click on a Scenes button to open the Scenes window.
Step 3. Add a custom name of your scene. Click on the name entry
field and type the custom name.
Step 4. Select a desired a scene and click a
configuration.
Load a scene
Step 1. Click on a Scenes button to open the Scenes window.
Step 2. Choose the proper scene and click the
it.
Delete a scene
Step 1. Click on a Scenes button to open the Scenes window.
Step 2. Choose the proper scene and click the
it.

Scenes

47
icon to save the actual

icon beside to load


icon beside to delete