Ac Electrical Specifications - Cisco ASR 9901 Hardware Installation Manual

Technical Specifications
Description
Shock
Vibration

AC Electrical Specifications

Caution
Be sure that the chassis configuration complies with the required power budgets. Failure to properly verify
the configuration may result in an unpredictable state if one of the power units fails. Contact your local sales
representative for assistance.
Cisco ASR 9901 AC Electrical Specifications
Description
Power modules per system
Total AC input power
Rated input voltage
Note
Rated input line frequency
Input current rating
Source AC service requirement
Redundancy
Value
Up to two AC power modules per system
1633 VA (volt-amps) per AC power supply (up to two AC power supply
modules per system)
100–240 VAC nominal (range: 90 to 264 VAC)
For each AC power 220–240 VAC (UK)
supply module.
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz (UK)
15 A maximum at 100 VAC
13 A maximum at 220 to 240 VRMS (UK)
15 A North America and Japan; 10 A international; 13 A UK
Power redundancy requirements vary, based on system configuration
(number and type of line cards, etc). AC powered systems are 1+1
protected.
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
AC Electrical Specifications
Value
Operating (halfsine): 21 in/sec (0.53 m/sec)
Nonoperating (trapezoidal pulse): 20 G, 52 in/sec
(1.32 m/sec)
G is a value of acceleration, where 1G
Note
equals 32.17 ft/sec2 (9.81 m/sec2).
Operating: 0.35 Grms from 3 to 500 Hz
Note Grms is the root mean square value of
acceleration.
Nonoperating: 1.0 Grms from 3 to 500 Hz
143