Cisco Asr 9001 Router Fixed Ports And Modular Port Adapters - Cisco ASR 9901 Hardware Installation Manual

Cisco ASR 9001 Router Fixed Ports and Modular Port Adapters

Note Due to the orientation of the QSFP28 ports (20 and 21), you might not be able to disconnect fiber optic cables
while the QSFP28 transceiver module is installed in the port. To disconnect fiber optic cables from the QSFP28
ports, we recommend that you first remove the QSFP28 transceiver module from the port, then remove the
cable.
Cisco ASR 9001 Router Fixed Ports and Modular Port Adapters
This section describes the fixed ports and modular port adapters on the Cisco ASR 9001 Router.
Fixed 4x10-Gigabit Ethernet Ports
The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that operate
at a rate of 10 Gbps.
Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the status
of the associated SFP+ port.
Note In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default, and
can be enabled by a license upgrade.
The following figure shows the front panel of the chassis and connectors of the fixed 4x10-Gigabit Ethernet
ports.
Figure 82: 4x10-Gigabit Ethernet SFP+ Ports
1
2
3
4
Cisco ASR 9901, ASR 9001, and ASR 9001-S Routers Hardware Installation Guide
74
Service LAN and ToD 6
ports
10MHz and 1PPS 7
indicators
SYNC (BITS/J.211) ports 8
CONSOLE and AUX 9
ports
Installing Modules and Cables in the Chassis
External USB port
Eight discrete LED
indicators
CLUSTER ports
Fixed SFP+ ports