Real Good Toys Victorian Painted Lady Instructions Manual page 34

Instructions for kit #JM-4600
Finish the Inside...Plan Ahead!
Interior finishing involves so many choices! Will this house
be a play-house or a display for miniatures? What accessories
will be used and where will they go? Wiring? Wallpaper? Tile
or carpeting? Every choice makes a difference in the order of
finishing. Real Good Toys has provided materials for some
basic interior work, but you may choose to do it differently.
Make your choices
Get your materials
Test your layout
With the pieces in your hands, imagine the steps to get to
where you want to be.
Now you're ready for your order of interior finishing.
Here's the order that our assembly pro follows for tackling
most custom interior finishing:
• Dividers
• Electrical wiring (using "tape" style wiring)
• Wallpaper (using methylcellulose paste)
• Interior Window and Door Trim
• Stairs
• Flooring
• Baseboard and crown moldings
□
68. Set the Oval Window's printed Pane
in the notch on the back edge of the frame.
Install the Oval Window Interior Trim
□
69. Lay out Dividers without glue lined
up with the stairhole; use other Dividers
as "squares"... straight front-to-back and
up-and-down. Mark their location. To glue
Dividers in, apply glue, tip the Divider and
put it almost all the way in, set the base, lift
the next-higher floor for some clearance, tip
the Divider upright, and slide it the rest of the
way in place, clean-up the excess glue.
The 1st floor Divider must have the doorway
closer to the front and the 2nd floor Divider
has the doorway closer to the back.
□
70. Assemble the Stairs: Lay a piece of
tape sticky-side-up on the table. Glue and
gently lay the Stair parts on the tape, lined
up on the edges (Illustration #70). Stretch
the tape and push down on the stair parts to
stick them to the tape. Check the edges, add
weight, and let the glue dry
Glue the Stairs to the floors and Dividers.
Test then glue the Stringers to the back of
each Stair
That's it! You're Done
Congratulations!
□
67. Window Interiors: The outside Frames were
installed in step 59 along with other outside finishing.
When the inside is ready for the window interiors (see
"Plan ahead" at left), lay each window Frame on it's
wide face and set a Window Pane the same size on it,
painted face up, and lined up around the edge of the
narrow face
.
Tape the Pane to the Frame. Keep the tape close to the
edge so it won't be visible thru the window when it
is in the opening. Trim off the excess tape. Glue the
Inside Frames into the window openings
Interior Door Trim: Glue together the Interior Door
Trim (2 sets). When it is dry, glue and tape each set to
a door, lined up on the inside.
Illustration 67C
Interior Door Trim
Illustration #70
Stairs
Stringer
Attic Divider
Divider
Divider on the 1st floor:
the doorway is in front
Interior Finishing (9) page 34
Illustration 67B
Window Pane
Inside Window Frame
Glue on the Tower Roof after
all interior finishing is done
Stairs and Stringer