Real Good Toys Victorian Painted Lady Instructions Manual page 27

Instructions for kit #JM-4600
□
50. Tape together the Tower Roof set (two Corners, the
Face, two more Corners, then the Spacer), carefully lined up
at the bottom edge. Wait to include the Tower Roof Back,
use the Spacer to make the right space for the Back.
(Note: the Spacer may be glued in if you do not want access
the the room within the Tower Roof).
□
51. Turn the Tower Roof set over. Spread glue on all
the bevels except the ones that will touch the Tower Roof
Spacer. Fold up the set and carefully line up the last corner.
Tape the Roof set firmly together.
Illustration #51
Lined up
□
52. Glue and tape the Tower Roof Back to the roofset,
lined up at the top.
□
53. Glue the Tower Roof set into the Tower Ceiling's
groove. The flattened corner of the Tower Ceiling is the right
end. Tape the Tower Roof set to the Ceiling if necessary for a
good fit. When the glue is dry, decide whether you will keep the
Spacer as part of the rear Tower Roof. If not. cut-to-fit and glue
1 / x 1 / x 7 13 /
the Groove Fill to fill the un-used part of the
4 8 16
groove in the Tower Ceiling.
□
54. Test, then glue and tape the Eaves to the front edges
of the house roofs. Note: there is clearance between the Gable
Roof and the Right Eave for shingles.
Illustration #54
Eaves
Left-bottom Eave
Right Eave
Left Top Eave
Gable Roofs
Right Eave
Left-top Eave
Tower Roof and Eaves (5)
Illustration #50
Tower Roof set
Corners
Face
Lined up
Illustration #52
Tower Roof Back
Illustration #53
Left Top Eave
Left Top Eave
Gable Roofs
Clearance
Don't skip the "Eaves"!
If the Eaves aren't attached, the
Nosing and Trim won't fit.
Left Top Eave
Gable Roofs
Back
Spacer
Corners
Lined up
Lined up at the top
Right Eave
Clearance
Right Eave
Clearance
Flat corner identifies
the right end
Gable Roofs
Builders...
Right Eave
Clearance
page 27