Real Good Toys Victorian Painted Lady Instructions Manual page 13

□
13. Glue the Front Set to the Base spaced from the back edge with
the Dividers and centered side-to-side with the Front Spacers.
Stretch tape a little above the floor all the way from one Side Wall to the
other to tighten the Front Spacers. (Photo at right)
Press down on the Front set, remove the Dividers, clean up the glue
squeezings, then put the Dividers back.
Weight the Front set, check the position against the Dividers and Spacers
and let the glue dry.
Use the other Front Set to trace-and-paint the bottom of the Mid Floor
(Porch Ceiling) and the top of the Mid Floor (Balcony Floor). Trace-and-
paint the bottom of the Top Floor for the Balcony Ceiling.
Let the glue dry
□
14. Inspect the Front Set to be sure nothing has moved
while the glue was drying.
Remove the Side Walls. Tape (don't glue!) Dividers to the back
edge of Front Set, one on the left and one on the right. Tape the
Dividers to the back edge of the house to hold them straight.
(Illustration #14)
Complete steps 15 - 17 without letting the glue dry
□
15. Spread glue in the base and mid grooves of the Side Walls
(the base is identified by the clapboard profile). Put a Side Wall on the
Base (in the Side's base groove: Illus. #13). Tape the back edge of the
Side to the Base using the Gable Triangle as a support square. Tape the
lower front of the Side to the Inset with the prepared flap of tape. Tape
the upper flap of tape from the Inset to the Side with a Front Spacer
spacing and supporting the Side. (Illustration #15)
Illus. #15
Front Spacer
Side Wall
Floors and Walls (1) page 13
TEMPORARY use
of the Dividers
Lined up
and taped
Don't glue the Dividers here!
Illus. #14
16" Flaps of tape