Real Good Toys Victorian Painted Lady Instructions Manual page 18

Instructions for kit #JM-4600
□
25. Lay out a set of Mid Bay Walls with all the clap-
board facing down on each Wall (Illustration #25). Tape the
Walls together and leave a 4" flap of tape on each end.
□
26. Turn the Bay Wall Set over. Spread glue in the
grooves and on all the ends. Tape the Bay Wall set to the
house. Line up and tape the Bay Wall set to the Bay Verti-
cals on the inside.
Inspect the Bay Verticals and the ends of the Bay Walls (Illustration #24).
When they are straight up-and-down, the outside point of the Bay Wall will
be the same for the Base set, for the Mid set, and all along the tip of the Bay
Vertical. When this is the way the Bay Walls fit all the way up the house on
both sides of the Bays, then they will be straight on the house
Without glue, put the Bay Vertical Corners in place to hold the vertical spac-
ing. (review Illus. #21C)
Illus. #26
Bay Walls
Bay Vertical, Sides
□
27. Attach 4 more Bay Vertical Sides to the Inset and Side
Walls abover the Mid Bay Walls (Illustration #24)
□
28. Build another set of Mid Bay Walls as you did in steps
25 and 26. Glue and tape the Mid Bay Wall set to the Top Floor on
the left. Keep the points of the Walls the same, as in Illustration
#26. Tape to the inside of the Attic Front (Illustration #28)
Temporary use of the Bay Vertical,
Corners - Don't glue them here
Illus. #25
Mid Bay Walls (3 3 /
8
Side (3 3 / )
4
Front (4
(a good thing!)
Line them up on the inside -
Keep the outside point the
same all the way up the
house
Illustration #28
left bay
The point is the same
as the lower Bay Walls
Walls and Floors (1) page 18
tall, grooved)
Side (3 3 / )
4
/ )
3
4
Lined up on the inside
Attic Front
Keep this corner tight